Cutting Conditions
S293X1-5
S293X1-3
S292X1-4
S292X1-2
S292X1-2 S292X1-4 S293X1-3 S293X1-5
Dc
Dc
Dc
Dc
cutting speed Vc (m/min)
feed per tooth Fn (mm/rev)
cutting speed Vc (m/min)
feed per tooth Fn (mm/rev)
cutting speed Vc (m/min)
feed per tooth Fn (mm/rev)
cutting speed Vc (m/min)
feed per tooth Fn (mm/rev)
Carbon Steel Materials
80
0.023xDc
70
0.023xDc
100
0.023xDc
100
0.023xDc
GR1 Carbon Steel
<24HRC Low-alloyed Steel <30HRC Hi-alloyed Steel 30~38HRC Hardened Steel 38~48HRC Hardened Steel
80
0.023xDc
70
0.023xDc
100
0.023xDc
100
0.023xDc
GR2
P
70
0.021xDc
60
0.021xDc
90
0.021xDc
90
0.021xDc
GR3
Hardened Steel Materials
50
0.020xDc
40
0.020xDc
50
0.020xDc
50
0.020xDc
GR4
H
40
0.015xDc
30
0.015xDc
40
0.015xDc
40
0.015xDc
GR5
Stainless Steel Materials
50
0.013xDc
50
0.013xDc
GR8-1 Ferritic 、 Martensitic
50
0.013xDc
50
0.013xDc
GR8-2 Austenitic
M
50
0.013xDc
50
0.013xDc
GR8-3 Austenitic-ferritic
Austenitic-ferritic Heat-resistant
40
0.012xDc
40
0.012xDc
GR8-4
Cast Lron Materials
80
0.023xDc
70
0.023xDc
100
0.023xDc
100
0.023xDc
GR9-1 Grey cast iron
K
80
0.023xDc
70
0.023xDc
100
0.023xDc
100
0.023xDc
GR9-2 Nodular cast iron
All cutting data serve for orientation only and should be adapted individually to the technical conditions on location 1. Please work with good rigidity / high precision facilities and collet chuck. 2. Please choose proper cutting fluid. 3. The cutting data is reference value only. Please adjust it according to your real working conditions. 4. If RPM is lower the reference value, the Feed rate (fz) and RPM should be reduced by the same proportion. 5. If vibration occurs during cutting, please reduce cutting parameter.
89
Made with FlippingBook - Online Brochure Maker