Cutting Conditions
F513SX
Dc
Dc
Dc
Dc
ae=0.4xDc ae
ae=0.1xDc ae
ae=0.02xDc ae
ae ae=Dc
cutting speed Vc (m/min)
feed per tooth fz(mm)
cutting speed Vc (m/min)
feed per tooth fz(mm)
cutting speed Vc (m/min)
feed per tooth fz(mm)
cutting speed Vc (m/min)
feed per tooth fz(mm)
Carbon Steel Materials
120
0.006xDc
120
0.006xDc
130
0.006xDc
140
0.007xDc
GR1 Carbon Steel
<24HRC Low-alloyed Steel <30HRC Hi-alloyed Steel 30~38HRC Hardened Steel 38~48HRC Hardened Steel
120
0.005xDc
120
0.005xDc
130
0.005xDc
140
0.006xDc
GR2
P
80
0.005xDc
80
0.005xDc
90
0.005xDc
100
0.006xDc
GR3
Hardened Steel Materials
65
0.004xDc
90
0.003xDc
90
0.003xDc
100
0.003xDc
GR4
H
60
0.003xDc
80
0.003xDc
80
0.003xDc
90
0.003xDc
GR5
Stainless Steel Materials
80
0.003xDc
90
0.004xDc
110
0.003xDc
130
0.003xDc
GR8-1 Ferritic 、 Martensitic
70
0.003xDc
80
0.003xDc
90
0.003xDc
100
0.003xDc
GR8-2 Austenitic
M
40
0.002xDc
50
0.003xDc
90
0.002xDc
60
0.002xDc
GR8-3 Austenitic-ferritic
Austenitic-ferritic Heat-resistant
30
0.002xDc
40
0.003xDc
40
0.002xDc
50
0.002xDc
GR8-4
Cast Lron Materials
110
0.006xDc
110
0.006xDc
120
0.006xDc
130
0.007xDc
GR9-1 Grey cast iron
K
120
0.006xDc
120
0.006xDc
130
0.006xDc
140
0.007xDc
GR9-2 Nodular cast iron
1. Please work with good rigidity / high precision facilities and collet chuck. 2. Please choose proper cutting fluid.
3. The cutting data is reference value only. Please adjust it according to your real working conditions. 4. If RPM is lower the reference value, the Feed rate (fz) and RPM should be reduced by the same proportion. 5. If vibration occurs during cutting, please reduce cutting parameter.
216
Made with FlippingBook - Online Brochure Maker