Cutting Conditions
F624HX
F623HX
F623HX F624HX
ae
Dc
Dc
cutting speed Vc (m/min)
feed per tooth fz(mm)
cutting speed Vc (m/min)
feed per tooth fz(mm)
ae
ap
ae
ap
Carbon Steel Materials
120
0.02xDc
0.2xDc
0.1xDc
120
0.023xDc
0.2xDc
0.1xDc
GR1 Carbon Steel
<24HRC Low-alloyed Steel <30HRC Hi-alloyed Steel 30~38HRC Hardened Steel 38~48HRC Hardened Steel
110
0.02xDc
0.2xDc
0.1xDc
110
0.022xDc
0.2xDc
0.1xDc
GR2
P
100
0.018xDc
0.2xDc
0.1xDc
100
0.021xDc
0.2xDc
0.1xDc
GR3
Hardened Steel Materials
60
0.015xDc
0.02xDc
0.02xDc
60
0.015xDc
0.02xDc
0.02xDc
GR4
H
55
0.012xDc
0.02xDc
0.02xDc
55
0.012xDc
0.02xDc
0.02xDc
GR5
Cast Lron Materials
120
0.02xDc
0.2xDc
0.1xDc
120
0.023xDc
0.2xDc
0.1xDc
GR9-1 Grey cast iron
K
120
0.02xDc
0.2xDc
0.1xDc
120
0.023xDc
0.2xDc
0.1xDc
GR9-2 Nodular cast iron
All cutting data serve for orientation only and should be adapted individually to the technical conditions on location 1. Please work with good rigidity / high precision facilities and collet chuck. 2. Please choose proper cutting fluid. 3. The cutting data is reference value only. Please adjust it according to your real working conditions. 4. If RPM is lower the reference value, the Feed rate (fz) and RPM should be reduced by the same proportion. 5. If vibration occurs during cutting, please reduce cutting parameter.
270
Made with FlippingBook - Online Brochure Maker