Cutting Conditions
F638TX F649TX
Dc
Dc
Dc
ae=0.4xDc ae
ae=0.2xDc ae
ae ae=Dc
cutting speed Vc (m/min)
feed per tooth fz(mm)
cutting speed Vc (m/min)
feed per tooth fz(mm)
cutting speed Vc (m/min)
feed per tooth fz(mm)
Carbon Steel Materials
60
0.006×Dc
70
0.006×Dc
80
0.006×Dc
GR1 Carbon Steel
<24HRC Low-alloyed Steel <30HRC Hi-alloyed Steel 30~38HRC Hardened Steel 38~48HRC Hardened Steel
60
0.005×Dc
70
0.005×Dc
80
0.005×Dc
GR2
P
50
0.005×Dc
60
0.005×Dc
70
0.005×Dc
GR3
Hardened Steel Materials
45
0.003×Dc
65
0.003×Dc
70
0.003×Dc
GR4
H
40
0.003×Dc
60
0.003×Dc
65
0.003×Dc
GR5
Stainless Steel Materials
60
0.002×Dc
70
0.004×Dc
80
0.003×Dc
GR8-1 Ferritic 、 Martensitic
50
0.002×Dc
60
0.003×Dc
70
0.003×Dc
GR8-2 Austenitic
M
40
0.002×Dc
50
0.003×Dc
60
0.002×Dc
GR8-3 Austenitic-ferritic
Austenitic-ferritic Heat-resistant
30
0.002×Dc
40
0.003×Dc
50
0.002×Dc
GR8-4
※ All cutting data are for reference only. Please adjust according to actual machining conditions. 1. Please work with good rigidity / high precision facilities and collet chuck. 2. Please choose proper cutting fluid. 3. The cutting data is reference value only. Please adjust it according to your real working conditions. 4. If RPM is lower than the reference value, the Feed rate (fz) and RPM should be reduced by the same proportion. 5. If vibration occurs during cutting, please reduce cutting parameter.
274
Made with FlippingBook - Online Brochure Maker