Cutting Conditions
D433FN
D413
D430FN
D412
D412 D430FN D413 D433FN
Dc
Dc
Dc
Dc
cutting speed Vc (m/min)
feed per tooth fz(mm)
cutting speed Vc (m/min)
feed per tooth fz(mm)
cutting speed Vc (m/min)
feed per tooth fz(mm)
cutting speed Vc (m/min)
feed per tooth fz(mm)
Carbon Steel Materials
80
0.023xDc
80
0.023xDc
GR1 Carbon Steel
<24HRC Low-alloyed Steel <30HRC Hi-alloyed Steel 30~38HRC Hardened Steel 38~48HRC Hardened Steel
80
0.023xDc
80
0.023xDc
GR2
P
70
0.021xDc
70
0.021xDc
GR3
Hardened Steel Materials
50
0.020xDc
50
0.020xDc
GR4
H
40
0.015xDc
40
0.015xDc
GR5
Stainless Steel Materials
GR8-1 Ferritic 、 Martensitic
GR8-2 Austenitic
M
GR8-3 Austenitic-ferritic
Austenitic-ferritic Heat-resistant
GR8-4
Cast Lron Materials
40
0.008xDc
80
0.023xDc
40
0.008xDc
80
0.023xDc
GR9-1 Grey cast iron
K
40
0.008xDc
80
0.023xDc
40
0.008xDc
80
0.023xDc
GR9-2 Nodular cast iron
Aluminium Steel Materials
Wrought Aluminium alloys Aluminium cast alloys <10% Aluminium cast alloys >10%
200
0.01xDc
200
0.01xDc
GR10-1
200
0.01xDc
200
0.01xDc
GR10-2
180
0.01xDc
180
0.01xDc
GR10-3
Copper Steel Materials
60
0.01xDc
60
0.01xDc
GR11-1 Pure Copper
N
60
0.01xDc
60
0.01xDc
GR11-2 Brass
60
0.01xDc
60
0.01xDc
GR11-2 Bronze
Copper Steel Materials
100
0.01xDc
100
0.01xDc
GR12 Plastics
FRP CFRP Composite Material
80
0.01xDc
80
0.01xDc
GR13
All cutting data serve for orientation only and should be adapted individually to the technical conditions on location 1. Please work with good rigidity / high precision facilities and collet chuck. 2. Please choose proper cutting fluid. 3. The cutting data is reference value only. Please adjust it according to your real working conditions. 4. If RPM is lower the reference value, the Feed rate (fz) and RPM should be reduced by the same proportion. 5. If vibration occurs during cutting, please reduce cutting parameter.
300
Made with FlippingBook - Online Brochure Maker