E113X / E114X
Recommended Milling Conditions
Slotting
GR.3 Hi-alloyed Steel （ ~30HRC ）
GR.4 Hardened Steel （ 30~38HRC ）
GR.5 Hardened Steel （ 38~48HRC ）
GR.2 Low-alloyed Steel （ ~24HRC ）
GR.9 Cast Iron
GR.11 Copper
GR.1 Carbon Steel
Work Material
80
80
60
50
30
80
100
Vc m/min
RPM (min-1)
Feed (mm/min)
RPM (min-1)
Feed (mm/min)
RPM (min-1)
Feed (mm/min)
RPM (min-1)
Feed (mm/min)
RPM (min-1)
Feed (mm/min)
RPM (min-1)
Feed (mm/min)
RPM (min-1)
Feed (mm/min)
Code No.
Dc
E113X/E114X-2 2 11,000 135 11,000 135
7,000 5,300 4,250 3,550 2,950 2,200
90
6,350 4,450 3,500 3,050 2,500 1,900
70 75 90
3,950 2,750 2,200 1,900 1,550 1,150
40 45 50 55 55 50
11,000 135 15,500 200
E113X/E114X-3 3 7,400 E113X/E114X-4 4 5,950 E113X/E114X-5 5 5,300 E113X/E114X-6 6 4,450
200 235 315 310
7,400 5,950 5,300 4,450
200 235 315 310
100 125 130 130
7,400 5,950 5,300 4,450
200 10,500 300
235 315 310 295
7,950 6,350 5,300 3,950
300 300 300
100 100 100
E113X/E114X-8 8 3,300 300 E113X/E114X-10 10 2,650 280 2,650 280 1,750 125 1,500 95 955 50 2,650 280 3,150 300 295 3,300 295 125 3,300
ap:<3 0.3D ≥3 0.5D
ap:<3 0.3D ≥3 0.5D
ap:<3 0.3D ≥3 0.5D
ap:<3 0.3D ≥3 0.5D
ap:<3 0.02D ≥3 0.05D
ap:<3 0.3D ≥3 0.5D
ap:<3 0.3D ≥3 0.5D
（ mm ）
1. Please work with good rigidity / high precision facilities and collet chuck. 2. Please choose proper cutting fluid.
3. The cutting data is reference value only. Please adjust it according to your real working conditions. 4. If RPM is lower the reference value, the Feed rate (fz) and RPM should be reduced by the same proportion. 5. If vibration occurs during cutting, please reduce cutting parameter.
74
Made with FlippingBook - Online Brochure Maker