SENSOR TECHNOLOGY
INDUSTRIAL ASSEMBLY-TYPE DUCT SENSOR IKF1 (FORM B) WITH PASSIVE OUTPUT
TECHNICAL DATA
APPLICATION
Housing colour: Housing material:
silver-grey aluminium
The industrial assembly-type duct sensor IKF1 is used for measuring tem - peratures of liquids and gases in pipes, air ducts or tanks in the mechanical and plant engineering sector. A mounting flange (MF) is required for use in air ducts. If used in liquids, immersion sleeves made of brass with nickel plating (THMs) should be used. For aggressive media, immersion sleeves made of stainless steel V4A (THV) are recommended. Immersion sleeves or mounting flanges are not part of the delivery scope and must be ordered separately as accessories. Sensor wire extendable: depending on the cross-section of the conductor and the sensor unit type
Sensor tube material: Ambient temperature:
V2A (1.4301)
−30 to +100 °C Permissible atmospheric humidity: max. 95% rel. humidity, non-condensing Max. sensor temperature: 150 °C Electrical connection: screw-type terminals 0.14 mm² up to 2.5 mm², only at protective low voltage max. 30 VAC / 42 VDC Tolerances: PT1000 DIN EN 60751 B Mounting / attachment:
in immersion sleeves (THMs, THV) for fluids or with mounting flange (MF) in air ducts
Protection rating: Protection class: Safety and EMC:
IP43
III
according to DIN EN 60730
Sensor characteristic curves:
the sensor characteristic curves can be found in the ‘Miscellaneous’ section from the fitting length (EL), subtract 15 mm to determine the nominal length (NL) of the immersion sleeve, for example, EL = 65 mm corresponds to THV / 50 mounting flange for installation in air ducts: MF matching immersion sleeves in brass: immersion sleeves with brass plating can be found in the ‘Miscellaneous’ section
Immersion sleeves:
Accessories:
matching immersion sleeves stainless steel (V4A): immersion sleeves made of stainless steel can be found in the ‘Miscellaneous’ section Please follow the EMC directives, avoid parallel routing with mains voltage-bearing wires, or use shielded wires.
SENSOR
FITTING LENGTH (EL) 65 MM (FOR 50-MM IMMERSION SLEEVES)
FITTING LENGTH (EL) 115 MM (FOR 100 MM IMMERSION SLEEVES)
FITTING LENGTH (EL) 165 MM (FOR 150-MM IMMERSION SLEEVES)
PG
PT 1000
IKF1P 1000 / 50 Item no.: G9150020; € 71.20
IKF1P 1000 / 00 Item no.: G9150150; € 72.90
IKF1P 1000 / 150 Item no.: G9150280; € 74.30
III
ACCESSORIES
ITEM NO.
FEATURES
EURO / PG
MF
G9990160
mounting flange for integrated duct sensor
7.70 / III
ILLUSTRATIONS
Mounting flange MF
Industrial assembly-type duct sensor
IKF
223
Catalogue 2024
Prices valid from 01.01.2024 - 31.12.2024, prices may be subject to change | V1
Made with FlippingBook Annual report maker