AFTER DELIVERY
When you receive the machine, make sure that it has not been damaged during transportation and that no parts are missing. Only by giving us immediate advice can the necessary replacement parts be obtained. Ensure that all components are correctly adjusted.
GENUINE PARTS
K-Line spareparts and accessories havebeen specificallydesigned anddeveloped for themachines produced. We would call your attention to the fact that non-genuine parts and accessories are not recommended by K-Line. The use of such replacement parts frees K-Line from all liability and makes the warranty void. The installation and/or use of non-genuine parts may, because of technical characteristics of construction, modify or influence the performance of the machine negatively.
IDENTIFYING THE MACHINE FOR REQUESTING SPARE PARTS
The machine is identified by the serial number on the metal plate on the machine. When requesting spare parts or maintenance service, please indicate the model and number of your equipment to ensure prompt and efficient attention.
TRACTOR REQUIREMENTS 10-14 Horsepower x width of machine in feet 25-35 Kilowatt x meter width of machine in meters Tractor weight must be same as or greater than the towed unit. 4 x Double Spool (5 x Double Spool if Hydraulic Roller Option installed) Hydraulic valves
3 x Double spool (4 required if Hydraulic Roller Option installed)
Hydraulic operating pressure
2800 PSI approximately
DEFINITIONS USED IN THIS MANUAL
DISC ARM IDENTIFICATION (REAR VIEW)
VIEW FROM REAR OF MACHINE
FRONT ARM
REAR ARM
BOLT TENSION
Top plate bolt tension Min:75ft-lb / 135N-m Max:100ft-lb/135N-m
Disc bolt tension 250ft-lb / 340N-m
Figure 2
Figure 3
Figure 4
7
2995P2 & 2912P2
OPERATOR & SAFETY MANUAL
Made with FlippingBook - Online Brochure Maker