K-Line Ag © ___________________________________________________________________
Manual System
Depth Control
Insert pin in hole according to depth requirement
Rear roller controls depth, To work deeper adjust roller upwards . To work shallower adjust roller downwards. For initial depth setting start shallow. Operate machine for short distance and stop. Adjust depth control in small increments to achieve required depth. Ensure both wing modules operate at same depth. (folding wing models)
Fore and Aft, Tilt & tracking in line
Figure 15
IMPORTANT Fore and Aft or tilt level affects how machine tracks, straight tracking in line gives superior ground disturbance, better trash flow and more even disc wear. In general, start with front row of discs working ¾” (20mm) higher than back row of discs.
To adjust Fore and Aft Tilt (Trailing mode) See Page 16 to adjust for correct tracking in line
Fore and Aft tilt adjuster
After initial setting run machine at normal operating speed and stop. Stand behind machine to check if machine is tracking correctly. If adjustment is needed see figure 16
To adjust Fore and Aft Tilt (Trailing mode)
Rotate tilt adjustment to suit and lock See figure…. After initial setting run machine at normal operating speed and stop. Stand behind machine to check if machine is tracking correctly. If adjustment is needed follow figures 17 & 18 on following page
Figure 16
To adjust Fore and Aft Tilt (Linkage mode)
Turn top link to adjust
Page | 15
Made with FlippingBook - Online Brochure Maker