K-Line Ag © ___________________________________________________________________
Front Disc Gang Lateral Positioning
*NB - Be sure machine is tracking in line before attempting to make this adjustment page 19- 20.
The Disc positioning system is used for maximum soil disturbance and reduced ridging. Adjustment can be made for more precise weed control, soil disturbance and to compensate for disc wear. Start with factory settings Test run at normal operating speed and stop quickly. Check for ridges of undug soil. (follow ridge into machine) For ridges where front and rear discs throw away from each other see figure 19 at point (A), front gang should be adjusted to the right. Figure 20 shows correct adjustment to remove ridge. For ridges where front and rear discs throw towards each other see figure 19 at point (B), front gang should be adjusted to the left. Only adjust in small increments ½” or 12mm Re-check in hard soils as jump arms tend to flex more.
Figure 19 Top View
Move front gang left to remove ridges at B.
Move front gang right to remove ridges at A. See figure 20
L
R
Adjustable Front Gang
Remember , Full ground disturbance starts at 2 ½” 60mm
Figure 20 Rear View
Fixed discs on Rear Gang
Adjustable discs on Front Gang
Adjust so the rear disc cuts just down on the side of the front disc cut
A
B
A
Ridge
A
Page | 17
Made with FlippingBook - Online Brochure Maker