A F T E R D E L I V E R Y C H E C K L I S T
1. Check all pivot pins are fastened and anchor bolts are correctly tensioned. Follow tension specification. Pg 19 2. Before mounting wheel to machine, check all hub and rim contact surfaces
are undamaged and free of paint, dirt and grease. 3. Lubricate wheel studs with standard viscosity oil. 4. Tension wheel nuts for torque specifications. Pg 19 5. Check tires are inflated. Pg 19
6. Check discs and disc bolt tension to specified torque 250ft lb / 340nm 7. Ensure all appropriate safety decals are securely attached to machine . Pgs 14-18 8. Check hydraulic system is fully primed. Pg 21 9. Check all safety mechanisms are in place and operating correctly 10. Lubricate heavy rear roller bearings. This page 11. Instruction manual has been stored with machine.
W A R N I N G
WHEEL BEARINGS • Grease wheel bearings every 20 hours of operation. • Dismantle and repack with grease annually. LUBRICATION OF PURGABLE HEAVY DUTY REAR ROLLER BEARINGS • Continually rotate roller slowly while greasing. • Grease must purge past seals. • Grease every 8 hours. WHEEL HYDRAULIC CYLINDER HEIGHT ADJUSTMENT (Only applies to 2995P & 2912P) • Lower machine to ground level until hydraulic cylinders are free of pressure. • Loosen locking screws. See figure 4 5 • Move ram end pin. • Rotate ram end to desired setting. • Secure ram end pin and re-tension locking screws.
Adjusting screw
Locking screw
Figure 45
2912, 2962 & 2995P Speedt i l l er Power f l ex Ⓡ
Operator & Safet y Manua l
3 6
Made with FlippingBook - Online Brochure Maker