2940T 2965T Trailing Speedtiller Operating Safety Manual

AFTER DELIVERY

When you receive the machine, make sure that it has not been damaged during transportation and that no parts are missing. Only by giving us immediate advice can the necessary replacement parts be obtained. Ensure that all components are correctly adjusted.

GENUINE PARTS

K-Line spareparts and accessories havebeen specificallydesigned anddeveloped for themachines produced. We would call your attention to the fact that non-genuine parts and accessories are not recommended by K-Line. The use of such replacement parts frees K-Line from all liability and makes the warranty void. The installation and/or use of non-genuine parts may, because of technical characteristics of construction, modify or influence the performance of the machine negatively.

IDENTIFYING THE MACHINE FOR REQUESTING SPARE PARTS

The machine is identified by the serial number on the metal plate on the machine. When requesting spare parts or maintenance service, please indicate the model and number of your equipment to ensure prompt and efficient attention.

TRACTOR REQUIREMENTS

10-14 Horsepower x width of machine in feet 25-35 Kilowatt x meter width of machine in meters Tractor weight must be same as or greater than the towed unit. Hydraulic valves 2 x Double spool (required)

+ 1 x double spool for hydraulic tilt adjustment + 1 x double spool for hydraulic roller adjustment

Hydraulic operating pressure

2800 PSI approximately

DEFINITIONS USED IN THIS MANUAL

DISC ARM IDENTIFICATION (REAR VIEW)

VIEW FROM REAR OF MACHINE

FRONT ARM

REAR ARM

BOLT TENSION

Top plate bolt tension 75ft lbs/100 Nm

Disc bolt tension 250ft lbs/340 Nm

Figure 2

Figure 3

Figure 4

7

2940T - 2965T TRAILING SPEEDTILLER

OPERATOR & SAFETY MANUAL

Made with FlippingBook - Online Brochure Maker