Ⓡ
S P E E D T I L L E R S TA R T - U P T I P S
THIS IS A GUIDE ONLY AND MUST BE READ IN CONJUNCTION WITH THE PARTS & ASSEMBLY INSTRUCTION MANUAL 1) DEPTH CONTROL • Start by setting roller 40mm higher than discs on level service. • Ensure wing roller heights are set the same. ( Folding wing models only)
2) TILT ADJUSTMENT (SETTING TO REDUCE SIDEWAYS TRACKING) • Start with front disc 20mm higher than back discs. • Follow diagram for tilt settings. pg 25 • To adjust, turn top link and lock.
Tracking Left
Tracking Right
Front disc too high
Front disc too low
Figure 23
3) FRONT DISC GAN LATERAL POSITIONING IS FACTORY SET - See pg 27
4) SPEED RANGE • 8-15km/hr. (5.9mph) • Greater activity occurs at higher speeds. HEADLANDS/ TURNING • Always raise machine when on headlands and when turning.
WING LIFT CYLINDER LEVEL ADJUSTMENT (FOLDING WING MODEL) (See figure 24 to adjust) • Fully extend wings And lower machine to ground level • Release hydraulic pressure And remove pin • Loosen rod end couplings and rotate to desired setting • Tension locking screws on couplings • Insert and secure pins • Perform test run and check for even working depth. Figure 24
Wing lift Cylinder Level Adjustment
Locking Screws
Cylinder Pin
Fo l d i ng 3PL Speedt i l l er Power f l ex Ⓡ
Operator & Safet y Manua l
2 3
Made with FlippingBook - Online Brochure Maker