4
Drill pilot holes at marked points. Insert wall anchors only where you’re not hitting a stud (drywall/masonry). Line up the board with the pilot holes. Drive screws through the pre-punched circular holes into wall anchors or studs. Check with a level as you go and adjust as needed. DRILL & INSTALL ANCHORS (IF NEEDED). SCREW IN THE PANEL
STUD
DRYWALL
5
REPEAT FOR SECOND PANEL
Flush-mount the second tile accessory wall. Position it directly above, below, or aligned to the left or right of the first tile, following the same installation process. Ensure the tiles are tight with no visible gaps and slots are perfectly aligned with one another.
CONTINUOUS EQUAL SPACING
FLUSH MOUNT STACKED
ALIGN 2 ND TILE TO MOUNTED TILE.
CONTINUOUS EQUAL SPACING
FLUSH MOUNT SIDE-BY-SIDE
8 | ENGLISH
Made with FlippingBook - Online catalogs