Symptom
A blade appropriate for the material being cut is not used. If cutting is not possible even though the cutting pressure is set higher than necessary, the blade may be chipped. The mat’s adhesive strength has decreased, or the material is not secured. Possible Causes (or Results)
Solutions
Reference
Use a blade appropriate for the material being cut.
page 23
Replace the blade with a new one.
page 87
Replace the mat with a new one.
page 87
The blade is worn.
Replace the blade with a new one. Replace the material with one compatible with this machine. Adjust the setting for “Cut Pressure” in the settings screen.
page 87
The material is incompatible with this machine.
page 14
The cutting pressure (“Cut Pressure”) is incorrect.
page 10 page 27
Dust or lint has accumulated in the holder.
Clean the holder.
page 89
Not all of the material to be cut is cut. Some areas remain uncut.
Rearrange the patterns to slightly separate them. Set the number to “3” or higher in the “Pattern Interval” setting, and then rearrange the patterns or perform the auto layout function. Attach the material while keeping it within the adhesive area of the mat. Attach a high tack adhesive fabric support sheet to a mat or affix an iron-on fabric appliqué contact sheet to a fabric before cutting it. Firmly attach the fabric to the mat pressing the handle of the included spatula across the surface of the fabric.
The spacing between arranged patterns is too small.
page 10 page 49
5
The material extends from the adhesive area of the mat.
page 16
Fabric was cut without using a sheet for fabric cutting.
page 17 page 20
A fabric is not firmly attached to a mat that has a high tack adhesive fabric support sheet on its adhesive side. An iron-on fabric appliqué contact sheet is not firmly attached to a fabric. The cutting pressure (“Cut Pressure”) is incorrect. After using a mat with deep cut marks which completely went through the mat, the machine's surface where the blade points down ( a ) has cut marks.
page 20
Iron the entire contact sheet to affix it firmly to the wrong side of the fabric.
page 17
There are deep cuts completely through the mat.
Adjust the setting for “Cut Pressure” in the settings screen.
page 10 page 27
Contact the retailer who sold you this machine or the nearest authorized service center.
The material to be cut is not cleanly cut.
—
a
97
Made with FlippingBook - professional solution for displaying marketing and sales documents online