Drawing
Symptom
Possible Causes (or Results)
Solutions
Reference
Adjust the settings for “Draw Speed” and “Draw Pressure” in the settings screen. To draw thicker lines, increase the drawing pressure. To draw thinner lines, decrease the drawing pressure. To draw thicker lines, reduce the drawing speed. To draw thinner lines, increase the drawing speed. After adjusting the settings, perform a test/trial drawing operation. Follow the instructions in the message that appears in the screen. Touch the “OK” key to move the carriage to its initial position. Load the mat and perform the operation again.
The drawing speed (“Draw Speed”) or drawing pressure (“Draw Pressure”) is incorrect.
page 10 page 62
The drawn line is thicker (thinner) than intended.
For safety, the machine stops operating if the panel is touched while drawing.
The machine stopped while an operation is being performed.
—
Scanning
Symptom
Possible Causes (or Results)
Solutions
Reference
In “Scan to USB” mode, specify the paper size with the “Scan Size” setting. In “Direct Cut” or “Scan to Cut Data” mode, trim the image in the editing screen after scanning. Clean the scanner glass inside the machine. In “Direct Cut” or “Scan to Cut Data” mode, remove thin lines or dirt in the image editing screen. In “Direct Cut” or “Scan to Cut Data” mode, remove the lines in the image editing screen. Peel off the blue tape from the optional scanning mat before scanning.
page 83
The scanning area is incorrectly specified.
Unwanted images are scanned.
page 71 page 77
The scanner glass is dirty.
page 91
Scanning cannot be done cleanly (there are lines in the scanned image).
The original to be scanned is dirty or scratched. The original is transparent so the lines printed on the mat are being scanned. When the optional scanning mat is used, scanning is performed without peeling off the blue tape. The scanner lever is not correctly positioned for the thickness of the material
page 81
The lines printed on the mat are scanned.
page 81
The scanned image is red.
—
The scan image is out of focus.
Set the scanner lever position to "1".
page 9
98
Made with FlippingBook - professional solution for displaying marketing and sales documents online