ERROR MESSAGES
The following table lists some of the messages that may appear while the machine is operating as well as their corresponding solutions. Perform the necessary operation according to the instructions in the message or the solution described here. If the problem persists, contact the retailer who sold you this machine or the nearest authorized service center.
Error Messages
Causes / Solutions
A malfunction occurred. Turn the machine off, then on again.
Turn the machine off, then on again.
Built-in memory is corrupted. Initialize the memory.
The data on the machine’s memory is corrupted. Restart the machine. The message appears under the following conditions: - In “Direct Cut” mode, more than the maximum number of patterns have been detected for the cutting pattern. - In “Scan to Cut Data” mode, more than the maximum number of patterns are being saved as cutting data. Reduce the number of patterns being used. * Depending on the machine model, the maximum number of patterns will differ. Check the “Maximum Pattern Number” under “Machine Information” of the settings screen. - There are too many cutting lines to be created after large number of small patterns are scanned. - There are too many light tone patterns to be converted to two-tone (black and white) patterns while the image detection level is being adjusted. Scan images again after reducing the number of patterns arranged in the original. There is no scanned image or lines for scanning. Recheck the image to be scanned, and adjust the scanning area, image detection level and “Ignore Object Size” settings. In addition, change the image drawn on the original to one more easily scanned. - This message appears when you try to transfer data with a machine different than the one registered with CanvasWorkspace. - The registration of your machine has been canceled from CanvasWorkspace. Register the machine to be used again. Depending on the pattern, it may not be possible to save it to external memory (USB flash drive or CanvasWorkspace).
5
Cannot operate when there are too many patterns.
Cannot operate when there is no pattern.
Cannot read the data. Get the PIN code again and register to the machine.
Cannot save the data. Get the PIN code again and register to the machine.
Includes a special pattern that cannot be saved to external memory. Save the pattern in the machine’s memory.
Initialization of the blade position failed. Turn the machine off.
Turn the machine off, then on again.
Initialization of the head failed. Turn the machine off.
More than the maximum number of patterns are being combined. Reduce the number of patterns. * Depending on the machine model, the maximum number of patterns will differ. Check the “Maximum Pattern Number” under “Machine Information” of the settings screen. There is no pattern(s) to be cut out or drawn within the cutting area. To cut out or draw a pattern outside of the area, increase the setting for “Cut Area”, or move the pattern(s) into the area specified with “Cut Area” (page 10). Delete a file from the machine’s memory or USB flash drive.
No more patterns can be added to this combination.
No pattern in the effective area.
Not enough available memory to save the data.
99
Made with FlippingBook - professional solution for displaying marketing and sales documents online