■ Unloading the Mat
■ Checking the Test/Trial Cut Results Adjust the cutting pressure according to the test/trial cut results. Repeatedly perform test/trial cut and adjust the cutting pressure until the material is cut cleanly. With an Appropriate Cutting Pressure When the material is peeled off, a faint trace of the cut remains on the mat surface.
a Press
in the operation panel to feed out
the mat.
2
■ Changing the Auto Cutting Pressure If the material could not be cut cleanly, refer to the following table, and adjust the setting for the cutting pressure.
Note • Do not forcefully pull the mat while it is being fed out. Otherwise, damage, for example, to the feed rollers, may result. b Peel off the material from an area that is easily removable, such as a corner, and then slowly peel while maintaining an even pressure.
Test/Trial Cut results
Tips for adjustment
Pressure too light: Touch in the settings screen once to increase the pressure. Pressure too light: Touch in the settings screen once to increase the pressure. Pressure too strong: Touch in the settings screen once to decrease the pressure.
Part of the pattern is not cut.
The entire pattern is not cut.
There are deep cuts completely through the mat.
Changing the Cut Pressure Setting a Touch in the test screen to display the settings screen.
c Holding the mat with your hand, use the included spatula to carefully peel off the cut- out patterns.
a
a Spatula
Note • When peeling off the material, insert the spatula as level as possible into the space between the material and mat. Strongly rubbing the adhesive side of the mat may damage it.
27
Made with FlippingBook - professional solution for displaying marketing and sales documents online