h Check the pattern arrangement, and then touch the “OK” key. When using fabric, the patterns may not be cleanly cut if they are arranged near the edge of the fabric. In this case, move patterns so they are at least 10 mm from the fabric edge (the edge of the cutting/drawing area in the screen). • To re-edit the pattern arrangement after checking it, touch the "Edit" key. For details, see “Mat Layout Screen” on page 41. • Select the “Cut Area” setting appropriate for the mat being used. (See page 10.)
■ Drawing a Select “Draw” in the preview screen.
A preview of the line to be drawn appears.
3
The preview screen appears.
b Adjust the pen pressure. For details on adjusting the drawing pressure, see step f (page 63) in “Drawing”. c Touch the "Start" key to start drawing.
■ Loading the Material Load the mat with the material for cutting (drawing) attached.
When drawing the seam allowance on the wrong side of the fabric, attach the material to the mat with its wrong side facing up. • For details on attaching material to the mat, see “Reference Table of Mat and Material Combinations” on page 14. • Lightly insert the mat into the feed slot, and press in the operation panel. • For details on inserting the mat, see “Loading the Mat” on page 26.
When drawing is finished, the message appears in the screen. After you touch the “OK” key, the preview screen appears. • To perform test/trial drawing operations to adjust the drawing pressure, touch the "Test" key. For details, see “Test Cut (Trial Cut)” on page 25. • To cut around the drawn patterns, keep the mat inserted into the slot without pressing , and continue with the following cutting procedure.
65
Made with FlippingBook - professional solution for displaying marketing and sales documents online