e Attach the original that will be scanned to the mat.
■ Creating Cutting Data The procedure for creating cutting data differs depending on the mode. Grayscale recognition mode a Check the scanned image, and then touch the “OK” key.
Memo • In “Direct Cut” mode, the scanning mat cannot be used. • Depending on the machine model, the sizes of mats that can be used will differ. Check the “Maximum Scanning Area” under “Machine Information” of the settings screen. • Before attaching the material to the mat, use a corner of the adhesive side of the mat to test attaching it. f While holding the mat level and lightly inserting it under the feed rollers on the left and right sides of the feed slot, press in the operation panel. • For details, see “Loading the Mat” on page 26. g Touch the "Start" key to start scanning.
4
b In the image trim screen, use the touch pen to drag to trim the image to the size to be imported. • When trimming is performed, the “OK” key changes to the “Preview” key. If cutting lines are created, the outline of the scanned illustration will be black.
a
b c
Note
• When the scanner lever is raised, the following message appears.
a Image Detection Level Key Adjust the image detection level. b Ignore Object Size Key
Small unnecessary patterns (dotted lines, etc.) can be excluded from cutting data. For details, see “Specifying “Ignore Object Size”” on page 81. c Smoothing Setting Key Specify the level of smoothing applied to the image outline. For details, see “Adjusting Image Detection Levels” on page 81.
Scanning with the lever raised may result in blurry scans.
71
Made with FlippingBook - professional solution for displaying marketing and sales documents online