c Touch the “Scanning/Cutting Position
g When the following message appears, touch the “OK” key.
Adjustment” button in the settings screen.
The adjustment is finished.
The following message appears.
Note • To return the settings to their defaults, touch the “Reset” key in the screen shown below.
• Touch the “OK” key.
5
d Press
to feed in the mat. • For details, see “Loading the Mat” on page 26.
h Use “Direct Cut” mode to check the adjustment results. • For details on the “Direct Cut” mode, see “SCANNING FOR CUTTING (Direct Cut)” on page 69.
e After making sure that the scanner lever (on the left side of the machine) is lowered to “1”, touch the “Start” key to start cutting. See “Cutting” on page 26. Position adjustment cuts are cut, and then the cuts are scanned.
• Using the intersecting cuts on the left and right sides, the scanning position is automatically adjusted. f The adjustment results screen appears.
• If the center of the cut aligns with the center of the red circle, the position is properly adjusted. Touch the “Yes” key, and then continue with step g . • If the center of the cut does not align with the center of the red circle, the position is improperly adjusted. Touch the “No” key, replace the paper attached to the mat, and then repeat steps d through f to readjust the position.
93
Made with FlippingBook - professional solution for displaying marketing and sales documents online