New Products
HOW TO MAKE A STANDARD CONNECTION:
New to the market is TIR’s 3/8” Push-To-Connect valves. Using plastic half-cartridges that require low insert loads, TIR valves can now fit onto a wider variety of equipment. More reliable and efficient, the Push-To-Connect valves come comprised with a collet gripper, a Viton O-ring, and a plastic body that has stainless steel teeth for easy manual assembly. Simply pushing a tube into the valve creates a leak proof connection for your agricultural projects. FEATURES: • Can be used with plastic or soft metal tubes in both inch and metric sizes • As system (valve) comes under pressure, the teeth of the PTC grip more • Easy to assemble • High retention
1. CUT THE TUBE SQUARE Cut the tube square on end, and remove burrs and sharp edges.
2. PUSH UP TO TUBE STOP Push square end of tube into the fitting.
EQUIPMENT STANDARDS: - TIR E-Chip™ with 3/8” OD Inlet and Outlet tube fitting - Weather Pack Connectors
Maximum Pressure: 200 PSI (1378 kPa) GPM: 0-0.22 (0.85 LPM) CV Rating: 0.1 Current Draw: 0.85 AMPs
3. PULL TO CHECK IF SECURE Pull on the tubing to check that the connection is secure.
SV.4050.WP.C
The collet gripper has stainless steel teeth which hold the tube in position while the O-ring provides a leak proof seal.
4. TO DISCONNECT Depressurize the system. Push the collet square against the fitting. With the collet square held in position, the tube can be removed.
Collet
Stainless Steel teeth grip the pipe
NEW PRODUCTS | 7
6 | www.SprayerValves.com
Made with FlippingBook Online newsletter