TIRE AND WHEEL REPAIR 2017

TIRE & WHEEL REPAIR

19

DAYTON ADAPTERS FOR HEAVY DUTY BALANCER STANDARD CENTER ADAPTER EXTENSION KIT FOR STANDARD ADAPTER

8110785 8110786

20” - 22.5” 24.5” - 26”

Budd Adapter for Heavy Duty Balancers: Standard Center Adapter Stud Piloted Wheel Patterns 8x275mm, 10x11.25”, 10x335mm 8143935 FOR 22.5” & 24.5”

CLICK HERE FOR TIRE CHANGER CLAMP MATRIX CHART

4WD 4-WD WHEEL BEARING LOCK-NUT TOOL

BEARING, GREASE & SEAL RIGHT ANGLE GREASE GUN ADAPTER

• •

FOR 4-SLOT APPLICATIONS 1/2” DRIVE NOT FOR USE WITH IMPACT WRENCH

• •

REACH INACCESSIBLE GREASE ZERKS ATTACH TO ANY STANDARD GREASE GUN TO REACH CONFINED AREAS FOR CHRYSLER, DODGE AND PLYMOUTH FWD BALL JOINTS AND OTHER TIGHT PLACES

LINE CODE PART NO. DESCRIPTION LIS

27250 4-WD WHEEL BEARING LOCK-NUT TOOL

LINE CODE PART NO. DESCRIPTION LIS

COMBO 4-WD WHEEL BEARING LOCK-NUT TOOL

21600 RIGHT ANGLE GREASE GUN ADAPTER

HANDY PACKER BEARING PACKER

COMBINATION TOOL FOR BOTH 4-SLOT AND 6-SLOT APPLICATIONS NOT FOR USE WITH IMPACT WRENCH 1/2” DRIVE

QUICKLY FLUSHES OUT OLD GREASE AND REPACKS BEARINGS WITH LESS MESS WORKS ON BEARING UP TO 3 1/2” O.D. THE GREASE STAYS IN THE TOOL CAVITY, NOT ON YOUR HANDS.

• •

• TO PACK BEARING, PLACE THE BEARING ON THE PISTON. PRESS DOWN ON THE CAP UNTIL THE OLD GREASE IS FORCES OUT AND THE NEW GREASE SHOWS ON TOP OF THE BEARING

LINE CODE PART NO. DESCRIPTION LIS

27250 COMBINATION 4-WD WHEEL BEARING LOCK-NUT TOOL

RATCHETING LOCK NUT TOOL

LINE CODE PART NO. DESCRIPTION

CASE PK.

• DOUBLE-ENDED FOR BOTH SIZES OF RATCHETING STYLE LOCK NUTS • TWO TOOLS IN ONE: SMALL END

LIS

34550 HANDY PACKER BEARING PACKER

1

UNIVERSAL BEARING PACKER • FAST, EFFICIENT, THOROUGH • SIMPLY PLACE THE BEARING

FITS FORD 1986 - 1994 LIGHT TRUCKS WITH DANA 44 FRONT AXLE; LARGE END FITS 1985 AND NEWER FORD F150- F350 TRUCKS WITH DANA 80 FULL FLOATING REAR AXLE

BETWEEN THE PLASTIC CONES, TIGHTEN AND APPLY GREASE THROUGH THE FITTING ON THE END OF THE THREADED SHAFT FORCES OUT OLD GREASE AND EVENLY INJECTS FRESH GREASE

• PRESS TOOL INTO LOCK NUT AND ROTATE TO RELEASE THE RATCHET INSIDE THE LOCK NUT • TORQUE WRENCH IS USED WHEN INSTALLING • USE WITH 1/2” SQUARE DRIVE

CONE DIAMETER IS 4 1/2”

LINE CODE PART NO. DESCRIPTION

CASE PK.

LINE CODE PART NO. DESCRIPTION LIS

LIS

65250 UNIVERSAL BEARING PACKER

1

28000 RATCHETING LOCK NUT TOOL

Made with FlippingBook flipbook maker