4
TRANSFER TO COATED CERAMIC MUGS
For MULTITRANS FULL COLOUR, preheat the mug press to 160°C / 320°F with an unprinted mug in the element For MULTITRANS SILVER/GOLD – preheat the mug press to 150°C / 302°F with an unprinted mug in the element Set the timer to 180 seconds For MULTITRANS FULL COLOUR, for GHOST PRINTERS use 140°C / 285°F for 300 seconds For MULTITRANS GOLD/SILVER, for GHOST PRINTERS use 140°C / 285°F for 180 seconds Place mug to be printed into the mug press ensuring that the entire print is covered by the element when closed Use tight pressure (not so tight that you break the mug) Close press and start timer When timer goes off, remove the mug by its handle and place somewhere to cool down for about 1-2 minutes DO NOT remove the Multitrans paper from the mug Place in a bucket with luke warm water until completely cool Take the mug out of the water and slowly and evenly peel the paper off the mug Clean with rubbing alcohol to remove background “scuff marks” (on OKI) Bake in the oven for 20 minutes at 180°C
TRANSFER TO MIRRORS
Preheat your flat press to 160°C / 320°F Place the mirror on the rubber pad and heat it by holding the heating plate over the mirror for a couple of minutes (DO NOT CLOSE THE PRESS) Set the timer to 500 seconds to avoid having to open it halfway through the process Fix the multi-meter wire to an exposed flat part of the mirror (NOT UNDERNEATH THE PAPER) with heat tape and switch it on Place the silicone pad over the mirror (IT LETS HEAT THROUGH SLOWER SO THAT YOUR MIRROR DOES NOT CRACK) Use medium pressure Close press and watch the multi-meter When the multi-meter reaches 145°C, open the press Peel the transfer off immediately while hot Let it cool Loosen the plastic layer and peel it off Clean with rubbing alcohol to remove background “scuff marks” Bake in the oven for 20 minutes at 180°C
Made with FlippingBook - professional solution for displaying marketing and sales documents online