xLadder user manual-V2.0.0.6

3.1 DIN rail mounting

Mounting

How to mount a xLogic module and an expansion module onto a DIN rail:

1. Hook the xLogic Basic module onto the rail.

2. Push down the lower end to snap it on. The mounting interlock at the

rear must engage. 3. Hook the xLogic expansion module onto the rail

4. Slide the module towards the left until it touches the xLogic CPU. 5. Push down the lower end to snap it on. The mounting interlock at the rear must engage. 6. Remove the plastic cover in the expansion port of CPU and expansion module. 7. Plus the connector on the flat cable to CPU

Repeat the expansion module steps to mount further expansion modules.

Note:If you need install the expansion and CPU on different rows, you need

order the longer flat connection which is used to connected with CPU, the

longest distance can be 200meters between the CPU and the end expansion

module.

Removal

To remove xLogic:

if you have installed only one xLogic Basic:

1.Insert a screwdriver into the eyelet at the bottom of the slide interlock

and move the latch downward.

2. Swing the xLogic Basic off the DIN rail.

17

Made with FlippingBook - Online magazine maker