xLadder user manual-V2.0.0.6

if you have connected at least one expansion module to xLogic Basic:

1. Remove the connector on the flat cable

2. Slide the expansion module off towards the right.

3. Insert a screwdriver into the eyelet at the bottom of

the slide interlock and lever it downward. 4. Swing the expansion module off the profile rail. Repeat steps 1 to 4 for all other expansion modules.

3.2 Wall-mounting

For wall-mounting, first slide the mounting slides on the rear side of

the devices towards the outside. You can now wall-mount xLogic by means

of two mounting slides and two ØM4 screws (tightening torque 0.8 to 1.2

Nm).

Drilling template for wall-mounting

Before you can wall-mount xLogic, you need to drill holes using the

template shown below.

All dimensions in mm

Bore hole for Ø M4 screw, tightening torque 0.8 to 1.2 Nm

18

Made with FlippingBook - Online magazine maker