3.3 wiring xLogic
Wire the xLogic by using a screwdriver with a 3-mm blade.
You do not need wire ferrules for the terminals. You can use conductors
with cross-sections of up to the following thicknesses:
1 x 2.5 mm2
2 x 1.5 mm2 for each second terminal chamber
Tightening torque: 0.4.. .0.5 N/m or 3. ..4 lbs/in
Note
Always cover the terminals after you have completed the installation. To
protect xLogic adequately from impermissible contact to live parts, local
standards must be complied with.
3.4 Connecting the power supply
ThePR-12AC,PR-18AC, PR-24AC versions of xLogic are suitable for operation
with rated voltages of 110 V AC and 240 V AC. The PR-12DC,PR-18DC, PR-24DC
versions can be operated with a 12 or 24 VDC power supply.
Note
A power failure may cause an additional edge triggering signal.
Data of the last uninterrupted cycle are stored in
xLogic
19
Made with FlippingBook - Online magazine maker