5.5.4.4 Offset Yield Where The WHERE function is used to specify where you want the Offset Yield point coefficient (result) to display. Display the point on any of these views: • Results View • Graph Views using a Marker • Data Views (a column within the table)
5.5.4.5 Offset Yield Tolerance Your point result (coefficient) can make use of a tolerance to distinguish the result as either a “pass” or “fail” relative to your tolerance limits. When you use a tolerance, you specify two tolerance limits. If your result equals or falls within the range created by these two tolerances, the result is displayed in black text and is deemed a “pass”. If the result falls outside the tolerance range, the result displays in red text and is deemed a “fail”. Your L3 Series software also features a Tolerance view (TOL) that displays a tendency graph for the result. This graph displays whether the actual result is at the high or low end of the tolerance range you have established.
The Offset result displays Red (Out-of-Tolerance) since the value is less than the Limit 1 Tolerance of 112,500.00 Mpa.
Tolerance Limits on Offset Yield Point Result is outside the Tolerance Range, displays Red for “out-of-tolerance”
starrett.com
25
Made with FlippingBook - professional solution for displaying marketing and sales documents online