Technical training
Solar Technical Training Standard / V1 02072025
c. install heat/cold shrink tube on top of cable and cable lug, after cable lug has been crimped
Practice cutting and crimping main LV power cables:
a. copper and aluminium (special attention to the correct cable die-set)
b.
rubber and PVC insulation types
ELEMENT 11.7 - MARKING, ROUTING AND TERMINATION OF ALL CABLE TYPES
Learning objectives:
86) The participants can describe typical faults during termination, and ways to mitigate these typical faults (Knowledge, basic level)
87) The participants can perform the marking, routing and termination of all cable types (Skills, intermediate level)
The instructor shall:
Show examples of and explain different types of marking and their purposes for all cable types:
a.
cable and conductor
b.
cabinet diagram
Show examples of and explain important factors when routing all cable types, informing participants to refer to work instructions for the specifics:
a.
bending radius (why a minimum is important)
b.
not twisted
c.
distance between cable types and groups
d.
fastening of cables: fixed vs flexible
e.
cable protection tubes or edge protection
f.
cable glands
Show examples of and explain important factors when handling fibre optic cables:
a. handle with care due to fragility (lower cables individually, do not combine with other cables when handling)
Global Wind Organisation / www.globalwindsafety.org
51 / 100
Made with FlippingBook Ebook Creator