TECHNICAL GUIDE & PRODUCT USER MANUAL
HEIGHT SAFETY EQUIPMENT INSPECTION CERTIFICATE
Customer: Product:
Date of Manufacture:
Withdraw from Service:
Report No:
Serial No:
Component
Condition of fault to be checked
Checked
Cuts or tears Abrasion damage especially where there is contact with hardware Excessive stretching Damage due to contact with heat, corrosives or solvents Deterioration due to rotting, mildew or ultraviolet exposure
Webbing
Distortion of hook or latch Cracks or forging folds Wear at swivels and latch pivot pin Free movement of latch over its full travel Broken weak or misplaced latch springs Free from dirt or other obstructions
Snap Hooks & Karabiners
Excessive vertical movement of the straight portion of the D ring at its attachment point on the belt, so that the corners between the straight and curved sections of the D become completely exposed Cracks especially at the intersection of the straight and curved portions Distortion or other physical damage of the D ring Excessive loss of cross section due to wear
D Rings
Distortion or other physical damage Cracks and forging laps where applicable
Buckles & Adjusters
Belt tongues Open rollers
Broken, cut or worn threads Damaged or weakening of threads due to contact with heat, corrosives, solvents or mildew Cuts, abrasion or fraying Stretching Damage due to contact with heat, corrosives, solvents etc. Deterioration due to ultraviolet light or mildew
Sewing
Ropes
General Comments:
Final Appraisal:
Pass:
Fail:
Inspector:
Date:
CLEANING OF HARNESS: If soiled by dirt or grit, sponge down or hand wash with luke warm tap water using pure soap or soap flakes.Thoroughly rinse and hang harness to room temperature out of direct sunlight and not exposed to direct heat. If any other condition exists, consult inspection guide in operational instructions or contact 1300 783 606.
www.bsafe.com.au 1300 783 606 I 37
Made with FlippingBook - Online magazine maker