TECHNICAL GUIDE & PRODUCT USER MANUAL
GENERAL WARNINGS
All users of height safety equipment require training in its selection, care and use. The information contained within this manual does not constitute or replace the necessary training. Users of fall protection equipment should be in good physical condition, must not be under the influence of drugs or alcohol and must be mentally fit for the task at hand.
B-Safe provides and delivers product demonstrations showing the selection, care and use of height safety products. This is suited to equipment users, purchasing officers and safety personnel.
Users should be competent in the use of the equipment contained in this manual before starting any task that requires its use. Refer to AS/NZS1891.4 for guidance on the selection, use and maintenance of height safety equipment.
Always select equipment that provides sufficient freedom to carry out the job but reduces the fall distance to the minimum. ”A lanyard assembly should be secured to an anchorage point which is at a level which will result in the minimum free fall and the least total fall distance consistent with the wearer’s ability to carry out work tasks” AS/ NZS1891.1:2007
Always inspect the equipment prior to each use. Check date of manufacture and the 'remove from service dates' on the product label. The equipment cannot be used past the 'remove from service' date.
Look for damage to webbing (such as abrasion, cuts or damage by chemicals) and inspect all hardware such as buckles, D Rings etc.
I f the harness, lanyard, attachments strap, retracting reel or any other equipment has received a shock load, been used to arrest a fall then it must be returned to the supplier for inspection and certification or destroyed. (Note: - some Inertia Reels are serviceable – contact Beaver Brands for further information). All fall protection equipment devices supplied by B-Safe must not be altered or added to in any way. Any part of the equipment showing deformation or unusual wear must be taken out of service immediately and checked by a competent person. If any part of this equipment is exposed to chemical contamination, (e.g. some marking pens, paints, cleaning materials or hazardous atmospheres) the user should consult the manufacturer to determine whether the equipment is suitable for continued use.
All connections should be checked to ensure that they are complete and compatible prior to use with a test loading by the operator before use.
Employers should have a written procedure and provide a contingency plan for recovery or rescue to allow for a prompt response to recover a fallen/suspended person. Peer rescue is recommended.
Never use fall protection equipment for a purpose other than what it was intended for. Read and understand all instructions and warnings BEFORE using equipment.
www.bsafe.com.au 1300 783 606
6 I
Made with FlippingBook - Online magazine maker