TREX ENHANCE ® STEEL RAILING Horizontal Installation Instructions
» HORIZONTAL SWIVEL BRACKETS CAN BE USED UP TO A 45° ANGLE FOR TREX ENHANCE STEEL PANEL RAILINGS. » W HEN USING HORIZONTAL SWIVEL BRACKETS VERY IMPORTANT TO LAY OUT LOCATION AND ORIENTATION OF POSTS AND SWIVEL BRACKETS BEFORE INSTALLING SWIVEL BRACKETS. HOW TO INSTALL HORIZONTAL SWIVEL BRACKETS Attach Lower Swivel Brackets to Enhance Steel Posts 1. M easure 3 3/16" (8.1 cm) Installing Upper Swivel Brackets to Enhance Steel Posts
4
from top of post base plate. Mark with light line.
1
3" (7.6 cm)
2
2. Center lower bracket on post above the marked line and attach
using two #12 x 3/4 self-drilling screws (provided).
4. P lace panel into lower swivel brackets. Place upper swivel brackets temporarily onto top rail and mark post at underside of bracket location. If necessary use a clamp to hold brackets on top rail.
5
5. C enter upper bracket on post above marked line
How to Measure and Cut Bottom and Top Railings (When Required)
and attach using two #12 x 3/4" self-drilling screws (provided) .
3
Installing Panel to Brackets 6. Attach panels to brackets as per previous instructions.
7. Attach bracket covers, caps, and skirts as per previous instructions.
3. W ith lower brackets in correct swivel location, measure distance from inside of bracket to inside of bracket. Also allow for 1-1/2" clearance on each side for panel rails to attach to brackets. Cut panel as per previous instructions.
RUST-OLEUM® is a trademark of Rust-Oleum Corporation
8
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
EHSRHZ-0225
Made with FlippingBook. PDF to flipbook with ease