Milling Milling Cutters
Installation and Adjustment Method for Cast Iron Finishing Milling Cutter
1. Roughing inserts (ON..05..) 2. Locking wedge 3. Double-headed wedge locking screws 4. Wiper insert clamping screw 5. Wiper insert (LN12/15)
6. Adjusting screw 7. Wiper cartridge 8. Locking screw for wiper cartridge 9. Cutter
1. Clean wiper cartridge (7), completely release adjusting screw (6); 2. Clean each insert pocket, cartridge pocket, clean inserts and cartridges; 3. Install roughing inserts (1), wiper cartridges (7) and use finger to push them to the locating surface and lock the screws; 4. Install wiper inserts (5); 5. Measure the axial run out of each roughing (1) and wiper insert (5); 6. Adjusting wiper inserts height through adjusting screw (6); 7. Wiper inserts Max. run out should be higher than roughing inserts by 0.03- 0.06mm.
3
4
1
5
2
6
7
8
9
301
Made with FlippingBook - Online Brochure Maker