Turning ISO Turning Inserts
Cast iron, chilled cast iron and short chip malleable cast iron
Basic grade
Supplemental grade
AC100K K05(K01-K15) CVD coated grade, has thick and smooth wear resistant coating and very hard substrate, recommanded for grey cast iron high speed turning. AC102K K10(K05-K20) CVD coated grade, has thick and smooth wear resistant coating and hard substrate, recommanded for nodular cast iron high speed turning. AC202K K15(K10-K30) 1st choice for cast iron turning. It can deal with interrupted cutting due to its high wear-resitant CVD coating, used in finish to rough turning on cast iron at low to medium cutting speed.
PB90 K10(K01-K20) CBN grade. Suitable for grey cast iron and chilled cast iron interrupted finish turning due to its good edge strength and wear resistance. AT210A K15(K10-K20) Coated cermet grade. The combination of ultra-fine crystalline hard phase and composite bonding phase to provide a balance of abrasion resistance and chipping resistance; suitable for continuous and medium turning of cast iron materials; offer high-quality machining surfaces. AT202 K15(K10-K20) Uncoated cermet grade. It has excellent built-up edge resistance and good plastic deformation resistance. It can be used in nodular cast iron finish turning when surface quality, small tolerance or low cutting force are requested.
Non-ferrous metals
Basic grade
AW100K N15(N05-N25) Uncoated grade. It has both excellent wear resistance and sharp edge. Used in Al alloy rough to finish machining.
PD20 N10 (N01-N20) PCD grade, used in non-ferrous material and non-metal material machining which can have longer tool life, completely clean cutting and good surface quality.
Heat resistant alloys
Basic grade
Supplemental grade
AP010S S05(S01-S15) With extremely high hardness, structural and chemical stability, it can not only meet the needs of high cutting speed finishing stable working conditions, but also suitable for high toughness of medium or semi- finishing and other general working conditions. AP100S S10(S05-S20) 1st choice for heat resistant alloy. PVD coated grade has high hardness and plastic deformation resistance, can keep high performance and good wear resistance. AP301M S25(S15-S35) PVD coated grade. Used in low cutting speed or light interrupted cutting. Suitable for semi-roughing or continuous machining for a short time due to its good notch wear resistance and anti-heat shock capability.
AC100M S15(S05-S20) CVD coated grade, suitable for heat resistant alloy continuous high speed machining . AC200M S25(S15-S35) CVD coated grade, suitable for heat resistant alloy general machining.
Hardened materials
Basic grade
PB30 H10(H05-H15) CBN grade with low CBN content, is used in hardened steel continuous machining at high speed and light interrupted machining.
PB60 H15(H10-H25) 1st choice of CBN grade medium CBN content for hardened steel interrupted machining and continuous machining at medium speed.
45
Made with FlippingBook - Online Brochure Maker