TECHNICAL DATA SHEET Blueskin WP200 Self-Adhered Waterproofing Membrane
Physical Properties
Blue 60 mils (1.5 mm) 14 F (-10°C) and above 300% (To ultimate failure of
Pass 0.02 perms (1.14 ng/Pa.s.m 2 )
-Color -Thickness -Application Temp -Elongation (ASTM D412) -Tensile Strength (Membrane) ASTM D412 – modified -Peel Strength (ASTM D903) -Minimum Puncture Resistance – Membrane (ASTM E154)
-Flexibility at -15 F (ASTM D1970)
-Water Vapor Transmission (ASTM E96) -Lap Peel Strength @ 40 F (ASTM D1876) -Hydrostatic Head (ASTM D5385) -Moisture Absorption (ASTM D570-81)
rubberized asphalt) 325 psi (2.24 Mpa)
3.3 lbf/in (580 N/m) 231 feet (70 m of water) 0.1% maximum
9 lbs/in (1576 N/m) 50 lbs (222 N/m) minimum.
Packaging
-Gross Coverage 36” -Net Coverage* 36”
60 mils (1.5 mm) 66.7 ft. 36”
-Thickness -Roll Length -Roll Width -Top Surface -Bottom Surface
200 ft 2 186 ft 2
Blue, cross-laminated polyethylene (HDPE) Siliconized Release Film
*Based on 65 mm laps both sides and end laps.
Description Blueskin WP200 is a self-adhering waterproofing membrane consisting of SBS rubberized asphalt compound, which is integrally laminated to a blue, tough, high-density cross-laminated polyethylene film. The membrane is specifically designed to be self-adhered to a prepared substrate providing a high-performance waterproofing barrier even under hydrostatic head pressures to 231feet. Features -60 mil thick, SBS modified membrane -Unique side-lap feature offers superior water-tightness -Excellent cold weather application properties -Factory controlled thickness -No VOC’s and low odor -Fully adhered systems prevents lateral water movement -CCMC listed -Resists up to 231 feet of positive-side head pressure Limitations Non-resistant to oils and solvents. Not designed for use in direct contact with potable water or permanent exposure and must be covered to prevent damage from sunlight. Good practice calls for the membrane to be covered immediately following application. Refer to minimum cure time requirements of sealant and mastics prior to applying polystyrene insulation. Do not use in contact with flexible PVC/vinyl products. Use only Henry 925 BES Sealant for terminations and penetration sealant to assure sealant compatibility. Using solvent-based primers in below-grade applications is not recommended to avoid possible hazardous fume accumulations. Storage Store in original cartons, on pallets or elevated platform. Protect from weather or store in an enclosed area below 120 F. Double stacked pallets are not recommended. If double stacking is necessary, use a plywood sheet to distribute the load.
REVISION: 02/27/17
Henry Company 999 N. Sepulveda, Ste 800, El Segundo CA 90245-2754 Technical Services- Phone (800) 486-1278 – Email: techservices@henry.com www.henry.com
Made with FlippingBook Digital Publishing Software