2940P 2945P 2950P Speedtiller Powerflex Operator Manual

TYRE SAFETY & P R E S S U R E S

SERVICING PROCEDURES

• Always cage tyres before seating beads. • Never exceed stated pressures when seating beads. • Do not attempt to mount a tyre unless you have the suitable equipment and experienced personnel. • Inflating tyres can be dangerous. Always stand to the side when inflating. • Failure to comply could result in serious injury or death. • Load ratings of replacement tyres should meet or exceed weight requirements. • Correct pressure is 50PSI/345KPA. • Before mounting wheel to machine, check all hub and rim contact surfaces are undamaged and free of paint, dirt and grease. • Lubricate wheel stubs with standard viscosity oil. • Tension wheel nuts to 200 ft-Ib (270 Nm). • For field operation: Re-tension after 1st, 5th, then every 50 hrs of operation. • For road travel re-tension first 3 miles (5kms), 10 miles (15kms), and thereafter at 25 miles (40kms) intervals.

Figure 15

Figure 16

Tyre Pressures When Fitted With Standard 400/60R15.5 (18PLY)

TYRE PRESSURE Centre: 50PSI / 345KPA Wheel Nut Tension: 200 ft-Ib (270 Nm)

Figure 17

20

2940P, 2945P & 2950P POWERFLEX SPEEDTILLER

OPERATOR & SAFETY MANUAL

Made with FlippingBook - Online Brochure Maker