Cabinet Specifications

Cabinet Specifications D. The owner / owner representative reserves the right to reject qualified or alternate proposals and to award based on product value where such action assures the owner greater integrity of product. 1.03 QUALITY ASSURANCE – the following items are required components of this specification and cannot be modified. A. The wood laboratory furniture contractor shall also provide work tops and fume hoods to assure proper staging, shipment, and single source responsibility. B. Each cabinet shall be foam and shrink wrapped to ensure cabinet surfaces are protected until the time of installation. Blanket-wrap is not allowed because they do not stay with the cabinets after delivery and because they are not assured of being grease and dirtfree. C. SEFA Compliance and Assurance: Wood cabinets shall be capable of passing all tests contained in SEFA 8W. Documentation shall be provided showing independent testing and compliance with SEFA 8W. D. MAS and/or Green Guard Certification: Manufacturer shall provide current documentation proving compliance and certification with either MAS or Green Guard small-scale chamber emissions test. Wood products shall be MAS Certified Green® and/or GreenGuard® Certified. E. Casework shall be installed by a factory certified installer or Lifetime Warranty shall be negated to a 2 year warranty. F. Cabinets shall be manufactured with dowel construction placed on a maximum 63mm on-center. G. Cabinets shall use a minimum of 2 mechanical fasteners along with dowel construction in securing the toe-space panel. H. Cabinets shall use a full sub-top construction composed of a minimum of 3/4” veneer core plywood. I. Cabinet faces shall be vertically grain matched within door and drawer faces. J. Wall cabinets shall be provided with 3/4” X 4” screw strips at both the top and bottom behind the cabinet back and doweled into both cabinet sides. Screws shall be applied via pocket hole fastener systems. 1.04 SUBMITTALS A. Submit compliance statement with bid – see page 14 of this specification. B. Casework samples will be required and reviewed per specification. Samples shall be delivered, at no cost to the architect or owner, to a destination set forth by the architect or owner. This must be done seven (7) days before quotation deadline as a condition of approval of each bidder. Samples shall be full size, production type samples, as will be delivered for the project. Furnish the following: 1. One combination drawer and cupboard base unit, including one shelf. 2. One sample of all top materials shown or called for. 3. Sample of all mechanical service fittings, locks, door pulls, hinges, and interior hardware. C. Submit shop drawings for furniture assemblies showing plans, elevations, ends, crosssections, service run spaces, location, and type of service fittings. 1. Coordinate shop drawings with other work involved. 2. Provide roughing-in drawings for mechanical and electrical services when required.


A. The basis of this specification is Diversified Casework ( Millennium Series (Lipped Edge). No exceptions, deviations or alternates to the specified construction or materials are allowed. B. Lifetime warranty: The selected manufacturer must warrant for the life of the product in the application and location installed, starting at the date of acceptance or occupancy, whichever comes first, that all products sold under the contract referenced above shall be free from defects in material and workmanship. Purchaser shall notify the manufacturer’s representative immediately of any defective product. The manufacturer shall have a reasonable opportunity to inspect the goods. The purchaser shall return no product until receipt by purchaser of written shipping instructions from the manufacturer.

12 35 53.19 Wood Laboratory Casework - 16 | | 877.348.9663

Made with FlippingBook interactive PDF creator