Ⓡ
S P E E D T I L L E R S TA R T - U P T I P S
THIS IS A GUIDE ONLY AND MUST BE READ IN CONJUNCTION WITH INSTRUCTION MANUAL 1) DEPTH CONTROL • Start by setting roller 40mm higher than discs on level service. • Ensure wing roller heights are set the same. (Folding wing models only)
Tracking Left
Tracking Right
Front disc too high
Front disc too low
Figure 30
2) TILT ADJUSTMENT (SETTING TO REDUCE SIDEWAYS TRACKING) • Start with front disc 20mm higher than back discs.
• Follow instructions for tilt settings. pg 31 • To adjust turn front adjuster and lock.
3) FRONT LATERAL DISC POSITIONING • Front lateral disc positioning is factory set for standard operating conditions. • If adjustment is needed follow. pg 34
4) SPEED RANGE • 8-15km/hr. (5-9mph) • Greater activity occurs at higher speeds. • Slow down in rough terrain (such as rocky country).
5) HEADLANDS/TURNING • Always slightly raise machine when performing headlands (turning at end of run) etc. • For 3 point Linkage machines, raise machine with Tractor Linkage Height Adjustment so discs and rollers are not in contact with ground. • For trailing and Powerflex machines, raise machine with wheels so discs and rollers are just out of contact with ground.
6) ROAD TRAVEL SPEED LIMIT • 32kmh (20mph)
27
2982P SPEEDTILLER POWERFLEX
OPERATOR & SAFETY MANUAL
Made with FlippingBook - Online Brochure Maker