↑ HOME
Clone tool — source and target layers Watch what's in your crosshairs.
You can clone within the same active layer or set another layer as the source Active layer is the source by default.
Cloning within the same layer (usually with offset mode on) this is the default setup
Cloning across layers (usually with offset mode off)
Source point marked with the crosshairs pointer
Target layer Always it is the active layer
Source layer You can mark a layer as source in the layer options.
Source layer = target layer
Layer panel
Layer panel
Layer options pop-up
Learn more about using layer options on page 145
When you start the Clone tool, the active layer is set as a source. If you want to use another layer as the target, activate this layer after starting the Clone tool. Learn more about using layers in general in "Layers" chapter on page 139
Infinite Painter’s Manual
ref: manual_creative_clone_source_target
Creative Tools • Cloning • Page 223
Made with FlippingBook - Online magazine maker