2023-05-02_ART_V4

Safety training

GWO Advanced Rescue Training Standard / V4 2023-05-02

The height of the anchor point shall ensure that in the event of a fall there will be enough space below the anchor point to allow the shock absorber in a fall arrest lanyard to fully deploy whilst preventing the person who is falling from coming into contact with the ground or structure below the anchor point

Note

The GWO recommends an anchor point height of 6.75m for the rescue and evacuation exercises.

The recommended height is based upon the following formula, 𝑅𝑅𝑅𝑅 = 𝐿𝐿𝐿𝐿 + 𝐷𝐷𝐷𝐷 + 𝐻𝐻𝐻𝐻 + 𝐶𝐶 , Where,

RD

= Required fall distance clearance (minimum anchor point height)

LL

= = = =

Length of lanyard

DD HH

Deceleration distance (fall distance)

Height of suspended worker

C Safety factor The value for 𝐻𝐻𝐻𝐻 is the length of the suspended worker after a fall and includes factors like the height of the person and harness stretch, to account for these variables this is set to 2.00m. Using the value for 𝐻𝐻𝐻𝐻 (2.00 𝑚𝑚 ) , the maximum allowed values for LL (2.00m) & DD (1.75m), and the minimum allowed value for 𝐶𝐶 (1.00 𝑚𝑚 ), , we get, 𝑅𝑅𝑅𝑅 = 𝐿𝐿𝐿𝐿 + 𝐷𝐷𝐷𝐷 + 𝐻𝐻𝐻𝐻 + 𝐶𝐶 and, 𝑅𝑅𝑅𝑅 =2.00 𝑚𝑚 +1.75 𝑚𝑚 +2.00 𝑚𝑚 +1.00 𝑚𝑚 , therefore, 𝑅𝑅𝑅𝑅 =6.75 𝑚𝑚 . Therefore, GWO recommends that the anchor points used during the evacuation exercises are placed a minimum of 6.75m above the ground or any structure which a person may come into contact with, in the event of a fall.

Any equipment used during this GWO training module shall meet or exceed the minimum requirements of the national standards listed in table A1-1 When working in a country where there is no applicable national standard then the equipment shall meet or exceed the minimum requirements of the European standards

Note

Global Wind Organisation©2023 / www.globalwindsafety.org

155 / 181

Made with FlippingBook flipbook maker