Safety training
Control of Hazardous Energies Standard / V3 2023-12-04
The instructor shall:
Explain and demonstrate example(s) of how to establish an electrically safe work condition. The steps to establishing a safe work condition are:
a.
determine all supplies into the boundary
b.
interrupt the load current
c.
disconnect the equipment
d.
discharge stored energy (if required)
e.
visually verify
f. apply Lockout-Tagout (needs to be performed by a (Safe Isolation) Authorised Person)
g.
test for absence of voltage in all isolations
h. test for absence of voltage in the working area according to the approach boundaries
i.
ground the conductors (if required)
Ask the participants involving questions about the steps to establishing a safe work condition e.g.:
a.
what steps were performed?
b. how was each step performed? For example, ask the participants to re-state or summarise each step in their own words
c. why was each step performed? What is the justification for each step?
d. why were the steps sequenced in this way? “This sequence of steps is correct because….”
Please emphasise that participants should always comply with company specific rules and procedures along with national and regional legislation. This means that how to establish an electrically safe work condition could change depending on regional/company/WTG model rules
Note
Give constructive feedback to the participants´ explanations about the steps to establishing a safe work condition
The participants shall:
Engage in answering the questions and share understandings about the steps to establishing a safe work condition
Global Wind Organisation ©2023 / www.globalwindsafety.org
91 / 143
Made with FlippingBook Online newsletter maker