Safety training
GWO Basic Safety Training / V19 02052025
Text updated
•
BST Working at Heights Module
Section 10.2. Duration of the BST Working at Heights Module:
Text updated
•
Section 10.4. Equipment BST Working at Heights Module
Text revised and updated, including:
•
- Explanation of generic training “This enables the participants to conduct pre-use inspection and to use other safety equipment products compared to those taught during this module (based on the manufacturer’s user manual). However, a location specific risk assessment might identify the need for additional instructions. - The introduction of safety instruction “Additional fall protection must always be used during training activities at height. The training provider shall introduce control measures that lower the risks and hazards associated with a fall from height to an acceptable level, following the Hierarchy of Controls in their risk assessment.”
Section 10.5. BST Working at Heights Module Timetable:
• The table is updated according to changes in the lesson 8 and the accompanying text has been updated.
Element 5.2 – Pre-use inspection
Learning objective 30 updated
•
5.2.2, 5.2.4, 5.2.6 and 5.2.7 updated
•
Element 5.3 – Correct attachment and Detachment
Text updated
•
Element 5.4 – Correct use
Text updated
•
Lesson 8 – Self Retracting Lifelines
• Entire lesson has been updated. Backup lines has completely been removed and focus has been placed on the use of SLRs in actual work in wind turbines.
Element 9.1 – Measures to prevent injury during training
• 9.1.5 Instructions about additional fall protect are updated
Section 10.7
• Assessment instructions made clearer to read
Global Wind Organisation ©2025/ www.globalwindsafety.org
285 / 312
Made with FlippingBook - Online catalogs