Technical training
Basic Technical Training Standard / V9 2024-06-24
• SS5.1.1 New letter bullet “c” inserted (all subsequent bullets progress one) “Ensure safety handles are mounted for use”
Annex 1 BTT-B equipment list.
• Safety handles added to hydraulic torque tools bullet points x2
• Bolt Tensioning Scenario. Extra parentheses removed and misspelling corrected
• Bolt Tensioning Scenario. Bullet amended to “Mock up for bolt tensioning…”
Annex 2 GWO Manual for Bolt Torquing (For Training Purposed Only)
• Introduction. Safety. Sentence added “If no safety handle is present do not perform operation.”
BTT Hydraulic Module
Element 10.2
• Changed element name to: “Element 10.2 - Collecting Oil and Grease sample”.
Added text to 10.2.1: “or grease sample”.
•
Added text to 10.2.2: “or grease sample”.
•
Added text to 10.2.3: “or grease sample”.
•
• Added point 10.2.4: “Facilitate discussions about oil and grease cleanliness”.
Added text to 10.2.5: “or grease sample”.
Amendment date
Version
Approved by & date
May 2023
8
GWO TC May 2023
Description of changes
Changes throughout:
New layout
•
• GWO Requirements for Training – title updated Safety lessons:
• Three safety lessons previously found in BTT V6 in the BTT Mechanical, Electrical and Hydraulic modules (Mechanical Safety, Electrical Safety and Hydraulic safety) have been re-added, with an exemption clause for participants who have completed the GWO CoHE training. • Duration instructions and timetables updated for all modules to align with the GWO Requirements for Training Section 4 Scope:
Revised and updated
•
Global Wind Organisation / www.globalwindsafety.org
289 / 298
Made with FlippingBook Digital Proposal Creator