Technical training
Basic Technical Training Standard / V9 2024-06-24
Section 5 General requirements for GWO training:
Bolt tightening added
•
• Medical requirements, WINDA ID, physical demands etc. removed as this is covered by the GWO Requirements for Training.
• Aim adjusted to include bolt tightening and company specific training
• Times adjusted to accommodate the new Bolt Tightening module
• In the section on validity, the term “assumption” is replaced with “expectation” and bolt tightening has been added
• Clarification on tiered prerequisites for Bolt Tightening and Installation Modules
Section 6.4 Handouts:
Bolt tightening handouts have been added
•
GWO Taxonomy:
• Replaced - The section Understanding the GWO taxonomy has been replaced with a general instruction and referral to the GWO taxonomy found in the GWO Requirements for Training
Section 7.5 Participant Performance Assessment:
• Written test requirement adjusted so as not to cover the Bolt Tightening module
• List of forbidden objects expanded to include smartwatches and other similar devices
BTT Mechanical Module:
• Learning objective: “Perform the correct use of hydraulic torque and tensioning tools (Skills, intermediate level)” deleted.
• Timing adjusted according to the deleted lesson
• Hydraulic torquing and tensioning deleted from the timetable and times adjusted
• Lesson on Hydraulic Torquing and Tensioning deleted
Bolt Tightening Module:
• Bolt Tightening module added including BTTM prerequisite
Installation Module:
• Prerequisites for module updated following addition of Bolt Tightening Module
Annex 1 - Equipment List:
Note on “not calibrating” tools deleted
•
Global Wind Organisation / www.globalwindsafety.org
290 / 298
Made with FlippingBook Digital Proposal Creator