Technical training
Basic Technical Training Standard / V9 2024-06-24
Amendment date
Version
Approved by & date
March 2019
5
GWO TC March 2019
Description of changes
Taxonomy alignment throughout Content changes:
• Participant performance assessment updated with ‘each module’ to allow participants to pass the individual modules & time allowed for each question increased to 1.5 minutes. Mechanical Module:
• Element 3.4.2 inserted ‘Explain the importance ...’
• Element 3.4.4 inserted ‘describe typical examples ...’
• Element 5.2.1 inserted ‘explain types of tools ...’
• Element 5.2.1 & 5.2.2 inserted importance of pre-use check
• Element 5.3.1 & 5.3.2 swapped to make chronological sense
• Element 5.4.1 changed to ‘function of feeler gauges’
• Element 5.5.1 changed to ‘function of callipers’
• Element 5.6.1 changes to ‘function of dial gauges’
• Element 6.1.2 & 6.1.4 inserted ‘how to inspect hydraulic ...’
Electrical Module time changes (not affecting overall module duration):
• Introduction to electricity reduced from 90 to 70 min.
• Electric circuits increased from 80 to 120 min.
• Electric components reduced from 120 to 100 min.
Electrical module content change:
• Element 3.1.2 inserted ‘the importance of working to ...’
• Element 3.2.3 inserted megohmmeter as a source of HV danger
• Element 3.2.4 inserted ‘the requirement for HV training’
• Element 3.3.3 inserted ‘not all circuits protected by RCD’
• Lesson 4 LO’s removed demonstrate to lesson 6
Global Wind Organisation / www.globalwindsafety.org
295 / 298
Made with FlippingBook Digital Proposal Creator