Technical training
Basic Technical Training / V8 2023-05-02
11. THE BTT HYDRAULIC MODULE 11.1 Aims and Objectives of the BTT Hydraulic Module The aim of the BTT Hydraulic Module is to give the participants the knowledge and skills to carry out basic hydraulic tasks (supervised by an experienced technician), using safe working procedures and the correct PPE.
After having successfully completed the BTT Hydraulic Module, participants will be able to:
Explain the basics of hydraulics (Knowledge, intermediate level)
1)
2) Explain risks and hazards associated with hydraulic work (Knowledge, intermediate level)
3) Describe the function of different types of pumps (Knowledge, basic level)
4) Perform check of start/stop pressure of a pump (Skills, intermediate level)
5) Describe the function of different types of actuators (Knowledge, basic level)
6) Explain the function of different types of valves (Knowledge, intermediate level)
7) Describe the function of accumulators (Knowledge, basic level)
8) Perform check and pre-charge of accumulators (Skills, intermediate level)
9) Describe the function of different types of sensors (Knowledge, basic level)
10) Recognise the components that transfer the oil (Knowledge, basic level)
11) Describe the handling of oil procedures (Knowledge, basic level)
12) Recognise and find different components on a hydraulic diagram (Knowledge, basic level)
13) Perform the accurate measurement of the hydraulic pressure (Skills, intermediate level)
11.2 Duration of the BTT Hydraulic Module The total contact time for completing the BTT Hydraulic module is 8 hours and 55 minutes.
The training provider must not exceed the time per day given in the table 11.2.1 below.
Maximum Duration Per Day
Contact time
8 hours
Total training day
10 hours
Global Wind Organisation / www.globalwindsafety.org
84 / 262
Made with FlippingBook Digital Proposal Creator