Fiber Optic Sconce with Tails (9FOWSF)
INSTRUCTIONS
Thank you for your purchase.
Inspect the entire unit immediately after you take it out of the box. If there is any concealed damage, please contact us immediately at 800-467-6222 to report. You only have 5 days to report damage for replacement or refund.
4537 Gibsonia Rd Gibsonia, PA 15044
Take time to familiarize yourself with the equipment, each component, and the recommended maintenance of this equipment before using or engaging any person with it. Please file this instruction sheet in an accessible location; this sheet must be read by and not alluded to anyone who is supervising or using TFH Equipment.
800-467-6222
info@tfhusa.com
Packing List
Box 1 Fiber Optic Light Source – 9FOLS Power Cord Box 2 Fiber Optic Tails Only – 91MSGL Box 3 Fiber Optic Sconce Only – 9FOWS (US item number)/9FOBXN (on box)
www.specialneedstoys.com
Wireless & Genie models include all of the above the above PLUS Combination Wireless Receiver – 9RGRX
Tools Needed: Philips’ Head Screwdriver , Flathead Screwdriver, Drill. Hardware needed: #8, 3/4” Wood Screws (2-4), Appropriate hardware
All TFH Products are to be used under adult supervision at all times.
TFH102024
1. Remove the Acrylic Mirror from the Sconce by gently squeezing the sides and wiggling it up. Set aside in a safe place. 2. Center the Fiber Optic Light Source on the back wall with the collar facing the sconce hole. Outline the white metal box with a pencil.
3. Remove the white metal cover of the Fiber Optic Light Source.
4. Place Fiber Optic Light Source inside Wall Sconce on pencil outline. There are predrilled holes in the bottom of the Fiber Optic Light Source. Mark with a pencil onto the back of the Wall Sconce.
5. Remove the Fiber Optic Light Source box and drill holes. 6. Replace the Fiber Optic Light Source box and screw into back of the Wall Sconce.
7. Replace the white metal cover on the Fiber Optic Light Source box.
All TFH Products are to be used under adult supervision at all times.
TFH102024
8. Insert the Fiber Optic Tails through the Sconce hole. Loosen the screw on the collar then insert the Tails into the collar of the Fiber Optic Light Source box. Hand tighten screw on the top of the collar.
9. Align the sconce at the appropriate height on preferred wall. 10. Drill pilot holes in the back of the sconce for appropriate mounting on your wall. Best to install in a stud. 11. Once mounted on the wall with appropriate hardware, run the power cord through the sconce hole and replace the acrylic mirror. 12. Carefully remove the protective film from the acrylic mirror.
Safety Precautions - The safety of your clients is dependent on the appropriate choice of activity to match yet challenge their physical abilities. Use appropriate spotting / safety techniques. In addition, the layout of your activity area, proper installation and maintenance of your equipment is critical. TFH equipment is not intended for general recreational use. Under no condition should this equipment be used without proper supervision. This sheet is for example only. It is not meant to, in any way, replace local, State, or Federal standards. Be aware - it is your responsibility to find all pertinent safety information that pertains to your facility.
All TFH Products are to be used under adult supervision at all times.
TFH102024
Page 1 Page 2 Page 3Made with FlippingBook - professional solution for displaying marketing and sales documents online