6
How to apply the products
Once you have identified what is causing the stain, and rectified the issue, removing the stain is quite simple just follow the steps below: a. Dechlorinate the pool – Lower the free chlorine residual in your water to 0. Leaving chlorine in the pool can neutralise the stain removers and make them less effective. b. Always ensure that you dose the required amount of Multi Stain Remover or Spotaway (or fibreglass pools) – Insufficient product may result in not all the stain being removed. c. Caution is required with coloured marble and vinyl pools – When using on coloured marble finishes or printed vinyl liners DO NOT allow direct contact with the pool surface. In these instances, it is recommended that you place the product in a sock attached to a telescopic pole and hold near the stained area. d. Always Add No More Metal – As soon as you see the stain lifting you should add No More Metal. This enables the metal ions that have lifted off the surface to be held in suspension in the water and deposited in the filter. Failure to add No More metal will result in the stains reappearing on pool surfaces. e. Always thoroughly backwash post stain treatment – This ensures any unwanted remnants of metal ions, organic matter and scale are removed from the filter. f. Stain treatment can cause the pool to go cloudy – Be prepared to use Miraclear Clarifier or Miraclear Gel Cubes to correct this post treatment.
www.lo-chlor.co.uk
Made with FlippingBook - Online catalogs