TREX SIGNATURE® X-SERIES™ STAIR CABLE RAIL Installation Instructions
15c
15d
Installing Compound Swivel Brackets in X-Series Anchor Posts
14
15c. Slide the bracket down until it sits on the cable infill adapter. Note that the screw in the locking assembly may need to be loosened to allow the locking assembly to fit properly in the X-Series Anchor Post.
15d. T ighten screw in locking assembly using a 5/32” Allen wrench.
Note: If locking assembly does not stay in place, use a flat head screwdriver or other tool to hold this down while tightening set screw.
Threading Push-to-Connect Fittings into Turnbuckles
16
Note: Cables removed from image above for clarity.
14. I nstall top rail onto X-Series Anchor Posts.
15a
Dovetail
15a. P osition the compound swivel bracket PARTIALLY into the X-Series Anchor Post as shown.
15b Locking Assembly
15b. S lide top rail locking assembly onto the dovetail on the top of both brackets.
16. Thread each push-to-connect (PTC) fitting into the turnbuckle on each short cable until the threads just disappear in the turnbuckle. Ensure threads are flush with the end of the turnbuckle.
6
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
XSSTC-0725
Made with FlippingBook. PDF to flipbook with ease