TREX SIGNATURE® X-SERIES™ STAIR CABLE RAIL Installation Instructions
Installing Long Cables into Push-to-Connect Fittings and Tensioning Cables
20
IMPORTANT NOTE: » If installing X-Series Cable Rail near saltwater environments, spray a small amount of WD-40 Specialist® Corrosion Inhibitor in the open end of the PTC fitting before inserting the cable. Do this IMMEDIATELY before inserting the cable to prevent dirt and dust from collecting inside the fitting. Use caution not to get this on the decking surface! Protect decking from drips and runs.
19
1/4 TURN MAX
1/4 TURN MAX
19. Push the end of each long cable into opposite PTC fitting, slightly rotating the PTC fitting counterclockwise and cable clockwise 1/4 TURN MAX until cable is fully seated.
20. H and-tighten all cables by holding the PTC fitting fixed and rotating the turnbuckle. Do NOT rotate PTC fitting when tightening cables.
8
Have Questions? 1–800–BUY–TREX
NOTE: Construction methods are always improving. Please ensure you have the most up-to-date installation instructions by visiting: trex.com
XSSTC-0725
Made with FlippingBook. PDF to flipbook with ease